Anderson Performance Carbon Fiber GT5 Hood, 2018-19 Mustang GT/V6/Ecoboost
$ 1,619.10$ 1,799.00
These parts are often built to order - please allow 2-6 weeks lead time
Flat rate shipping from Anderson Composite's Ontario, California locaiton to a commercial dock in the lower 48 United States can be added here "As an option" for $210. The base price shown DOES NOT INCLUDE SHIPPING and is for reference only. We would rather you CALL IN THIS ORDER and use this page as reference only, for a more accurate shipping quote to your location. Thanks!
The Anderson Composites double-sided Carbon Fiber "Style GT5" hood is a direct replacement for all 2018-19 Mustang hoods (other than Shelby models). We tested this very model on our 2018 Mustang GT.
It is made to mount with the factory hinges and factory hood latch and is a true DIY installation part. We were amazed that we could install the hood, set panel gaps, adjust the hood latch in under 30 minutes.
These double-sided hoods are real carbon-fiber replicas of 2020 Mustang Shelby GT500, with fully functional hood vents. These will work with factory hinges and latches.
We weighed the stock hood at 41.2 pounds on our 2018 GT and this carbon hood weighs only 27.3 pounds. This is a 14 pound weight savings over the stock aluminum hood, without any of the compromises of a Motorsports level dry carbon hood (which has to use hood pins and must be clear coated, painted, or wrapped). Glossy gel coat looks good, is super smooth, and should withstand the elements - but a clear coat or layer of paint never hurts.
This carbon hood has a fully-finished underside layer with enough structure in place to mount the factory hood hinges, latch, and prop rod - but we recommend not using any aftermarket lift struts.
This hood features a large 19 x 26-inch louvered vent totaling 3.43 square feet for heat extraction and reduced front end downforce.
Features and Notes:
CARBON FIBER "SKELETON" BONDED TO UNDERSIDE OF CARBON FIBER HOOD - REDUCED WEIGHT
MODIFICATIONS MAY BE NECESSARY FOR CORRECT FITMENT OF THE O.E. WINDSHIELD WASHER SPRAY NOZZLE SYSTEM AS PART OF THE NORMAL INSTALLATION PROCESS
MESH SCREEN S ARE REMOVABLE and PAINTABLE
MOUNTS WITH OE HARDWARE
Requires hood pins for safety reasons
Heat shield required
ALWAYS CAREFULLY CLOSE A COMPOSITE HOOD. SLAMMING OR DROPPING THE HOOD MAY CAUSE IT TO CRACK.
Call to order and to get a shipping quote
Shipping not included at this price
Watch the video below for installation details and features